Abstract: The anammox-based process ELAN (R) was started-up in two different sequencing batch reactor (SBR) pilot plant reactors treating municipal anaerobic digester supernatant. The main difference in the operation of both reactors was the dissolved oxygen (DO) concentration in the bulk liquid. SBR-1 was started at a DO value of 0.4 mg O-2/L whereas SBR-2 was started at DO values of 3.0 mg O-2/L. Despite both reactors working at a nitrogen removal rate of around 0.6 g N/(L d), in SBR-1, granules represented only a small fraction of the total biomass and reached a diameter of 1.1 mm after 7 months of operation, while in SBR-2 the biomass was mainly composed of granules with an average diameter of 3.2 mm after the same operational period. Oxygen microelectrode profiling revealed that granules from SBR-2 where only fully penetrated by oxygen with DO concentrations of 8 mg O2/L while granules from SBR-1 were already oxygen penetrated at DO concentrations of 1 mg O2/L. In this way granules from SBR-2 performed better due to the thick layer of ammonia oxidizing bacteria, which accounted for up to 20% of all the microbial populations, which protected the anammox bacteria from non-suitable liquid media conditions.

Abstract: A single stage partial nitritation and anammox granular pilot scale reactor (600 L) was operated to treat primary settled sewage in an urban wastewater treatment plant. The fed wastewater contained low total nitrogen concentrations of 6-25 mg TN/L and the system operated without temperature control ranging from 18 to 12 degrees C. A control strategy, based on the pH value, was applied to stop the aeration supply. The pH set-point was fixed at 6.0 and allowed obtaining a total nitrogen removal efficiency approximately of 50% treating a load of 67 mg TN/(L.d) without the addition of any chemicals. Although nitrite oxidizing bacteria were present in the inoculated sludge, when the pH-based control was implemented (day 30) the ammonium oxidation was favored compared to the nitrite oxidation activity. Then, the system operated stable the rest of the operational period (days 30-94) despite the presence of organic matter in the wastewater and the high variability of nitrogen load and temperature during the operation. Nitrogen was autotrophically removed accomplishing the stringent discharge limits (10 mg TN/L) and nitrate concentrations in the effluent lower than 3 mg NO3--N/L. Both biomass concentration and granules size increased during the operational period indicating the growth of the biomass inside the reactor and therefore the potential treatment capacity.

Abstract: The anammox process is an energy efficient promising alternative to biologically remove the nitrogen. Thus, a 5-L anammox granular reactor was inoculated with sludge coming from a sidestream partial nitritation and anammox reactor (>200 mg TN/L and 30 degrees C) and it was directly subjected to 15 +/- 1 degrees C treating mimicked municipal wastewater (50 mg TN/L). Results indicated that an acclimation period (commonly used) to progressive reach the mainstream conditions is not needed, shortening the start-up periods. The long-term anammox process stability was proved to treat synthetic wastewater with decreasing alkalinities and nitritified primary settled municipal wastewater. The low pH values (6.2 +/- 0.1) of the municipal wastewater fed did not affect the process stability. Residual organic matter concentrations augmented the nitrogen removal efficiency from 80 % (with the synthetic medium) to 92 % achieving effluent concentrations below 10 mg TN/L. Finally, the effect of pH (6-8), temperature (15-30 degrees C) and organic matter concentration (0-75 mg TOC/L) over the specific anammox activity (SA(Amx)) was evaluated at short-term. pH and temperature and their interactions exerted significant influence on the SAAmx value while the TOC concentrations itself did not significantly change the SA(AMX). (C) 2020 Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.

Abstract: A two-stage system (partial nitritation (PN) and anammox processes) was used to remove nitrogen from the dewatering liquor originating from the thermal hydrolysis/anaerobic digestion (THP/AD) of municipal WWTP sludge. Two strategies were tested to start up the PN reactor: 1) maintaining a fixed hydraulic retention time (HRT) and increasing the ammonium loading rate (ALR) by decreasing the feeding dilution ratio and 2) feeding undiluted dewatering liquor and gradually decreasing the HRT. With diluted feeding, the reactor performance had destabilization episodes that were statistically correlated with the application of high specific ammonium (> 0.6 g NH4+-N/(g TSS.d)) and organic (> 0.7 g COD/(g TSS.d)) loading rates. The second strategy allowed stable PN reactor operation while treating ALR up to 4.8 g NH4+-N/(L.d) and demonstrating that dilution of THP/AD effluents is not required. The operating conditions promoted the presence of free nitrous acid levels (> 0.14 mg HNO2-N/L) inside the PN reactor that inhibited the proliferation of nitrite oxidizing bacteria.
Batch activity tests showed that the inhibitory effects of organic compounds present in the THP/AD dewatering liquor on the ammonia oxidizing bacteria activity can be removed in the PN reactor. Thus, aerobic pretreatment would not be necessary when two-stage systems are used. The PN reactor effluent was successfully treated by an anammox reactor.
An economic analysis showed that using two-stage systems is advantageous for treating THP/AD dewatering liquor. The implementation of an aerobic pre-treatment unit is recommended for WWTPs capacities higher than 5.10(5) inhabitants equivalent when one-stage systems are used.